Help your fellow builder by leaving your feedback based on these three criteria:
- Originality: How original is this - never seen before?
- Building Techniques: How much skill do you think the creator of this MOC has, in terms of building technique?
- Details: Express how much you like the details of the build.
Your feedback is only shown to the creator as well as yourself. It is not available for other users to see. The creator won't see your user name.
The size is 63cm x 21.8cm in length and is similar to the actual 4/4 size violin(60cm x 21cm).
Total number of parts is 1,353.
-Wedge plates were used to represent the unique curves of the violin.
-The side wall(rib) was designed with the 'brick with knobs' in the way stud was seen.
[Peg box and Scroll]
-Wedge plates and round plates were used to express peg box and scroll.
-For Peg, # 75904 Hammer was used.
-Hinge plates were used to express the angle of the finger board
-Outer cables were used for strings. 256 mm and 96 mm outer cables are connected and they are naturally connected on the LDD
-In practice, 352 mm outer cables must be produced, or 256 mm and 96 mm outer cables must be connected to the connector peg(technic pin).
-The bow was designed using # 75535 part and tile
In addition, Chin rest, Bridge, tailpieace, tail gut, and end pin are also represented.